If you do a full packet capture, you will be able to look for the reassociation packets in the capture to confirm deauthentication worked. (I see that you already tried this one, some AP have a protection that if you're not "authenticated" it will drop a deauth from a random/unknown source for obvious reasons so always try to add the -c flag)Ĭlients may reconnect too fast for you to see that they had been disconnected. If this is the case, you will need to send a deauthentication directed at the particular client. Some clients ignore broadcast deauthentications. See the previous item for confirming the client received the packet. If your card is in a different mode then the client card there is good chance that the client will not be able to correctly receive your transmission. Wireless cards work in particular modes such b, g, n and so on. If there is no “ack” then likely it did not receive the packet. If you do a full packet capture, each packet sent to the client should result in an “ack” packet back. You need enough transmit power for the packets to reach and be heard by the clients.
You are physically too far away from the client(s). There can be several reasons and one or more can affect you: Second, have you tried the basic troubleshooting? Anyway if you see an output it mean that you typed it right. I even tried to deauth a specific device form router by aireplay-ng -deauth 0 60 -a -c wlan0mon, but still,the same case got repeated as above.įirst of all the command starts like this aireplay-ng -deauth 60 or aireplay-ng -0 60 for 60 packets or to send it continuously (DoS) aireplay-ng -deauth 0 or aireplay-ng -0 0. It repeated "Sending deAuth to broadcast - BSSID " the same line for 60 times, but not even a single device got disconnected from the hotspot. Then, I used aireplay-ng -deauth 0 60 -a wlan0mon to disconnect all the devices connected to that router. I used airodump-ng -c -bssid wlan0mon to show the details of devices connected to that router. Then, airodump-ng wlan0mon to list all the networks in its vicinity. I used airmon-ng start wlan0 to initiate my wlan for aircrack-ng. syntax was correct and it started running, but, no device is being disconnected from my mobile hotspot.
I wanted to deauth any device connected to my mobile hotspot using aireplay-ng. I was using aircrack-ng for pentesting my wlan network. I've updated all tools and services by apt-get update and apt-get upgrade.
0 kommentar(er)
